Do you want to restore the look of your antique floor? Sanding your floor covering is the option available to you. It is mainly a technique that involves cleaning or stripping a surface by abrasion. The purpose of sanding an antique floor is to restore your floor to its original shine and condition. However, it is clear that not everyone can achieve a successful antique floor sanding. In fact, to achieve this, it is important to follow certain basic steps. Find out which ones in this article.
Like all construction or renovation work on a house, sanding old floors requires the use of a few materials. Obviously, the floor sander is the main machine you will need to have on hand. Ideally, always choose a floor sander with a built-in vacuum and a dust bag. Safety goggles, a mask and earmuffs can also be useful. Not to mention the large quantity of coarse, medium and fine grit sanding belts.
In general, sanding a floor is done in a few key stages. Note that before starting the process, you must first evaluate whether your old floor can still be salvaged or whether a permanent replacement is required for the safety of residents. Once this is done, you must start by preparing your floor. To do so, before removing all screws, drive all nails into the wood to prevent them from tearing the sanding strips you will be using. Then, make sure to replace the damaged boards for a job well done. Lastly, the last step for this preparation is to remove all possible traces of old varnish with a steel pad soaked in white spirit. A way for you to prevent the sanding belt from becoming pasty.
For this stage, you will particularly need a floor sander to flatten the floor with an abrasive paper. Generally long and delicate, this work does not require any particular experience and can be done by yourself. For this, be sure to equip your sander with a coarse-grained belt. Then, you can start on one side of the room, being careful to place your back against a perpendicular wall in the direction of the boards of your old floor. For an impeccable finish, also remember to tilt the sander back and gently hold it in place throughout use. Note that the floor sander is a cumbersome and heavy device, which means that its handling requires good concentration.
To properly sand your old floor, you must move forward in the lengthwise direction of the floorboards to avoid damaging the wood of your floor. However, if it protrudes, you must go slightly diagonally. Avoid approaching the baseboards, pressing too hard or staying in one place for long periods of time. This will prevent any form of damage caused by the floor sander.
Continue scrupulously pressing the floor down to the inside of the cracks once sanding is completed. This operation should be done twice in the direction of the wood by providing the sander with a medium-grain and then fine-grain belt. Then sand the edges with a disc sander, always paying attention to the baseboards.
You will also need to vacuum everywhere to remove wood residues from the floor, while taking care not to get the floor wet. Finish the sanding process by wiping your old floor with a dry cloth to remove dust and observe the final finish of your refinished floor. Keep in mind that you can always make your life easier by first disassembling and numbering the baseboards and then putting them back in their place at the end of the sanding process. Basically, these are the basic steps of an antique floor sanding. Depending on your desires, you can choose to varnish your previously sanded floor for a perfect and sublime finish.